Classic Cleaners 027 303 8398
Washing the soffits of a brick-and-tile house with a cabbage tree in the garden

Auckland · Soft wash

Soft wash or water blasting: what's safe on Auckland weatherboards

The boards want low pressure. The driveway can take more.

Auckland has a lot of weatherboard houses. Villas and bungalows in Ponsonby and Grey Lynn, Mt Eden and Devonport, and plenty of later timber and fibre-cement boards across the rest of the city. They look good when they're clean, and they mark easily when they're not.

The question is how you clean them. A lot of people reach for a water blaster, because that's the machine they already have, or the one they've seen used on a driveway. On weatherboards, that's the wrong tool.

What a water blaster does to boards

A water blaster is a high-pressure jet. On concrete, that's useful. On painted timber or fibre-cement, it can lift paint, chew the edges of the boards, and drive water in behind the cladding and into the joinery. Once water is behind a board, it sits there. That's how you get swollen timber, bubbling paint and damp in places you can't see from the lawn.

It also isn't a very good mould treatment. The jet knocks the green off the surface and leaves the rest. A few months later the south wall is coming back, sometimes faster than before, because the surface has been roughened up.

Older paint is the most vulnerable. A villa that hasn't been painted for a while will show it first. Even a recently painted house isn't a good candidate for high pressure. The paint is still a thin film, and a blaster doesn't care.

What a soft wash does instead

A soft wash in Auckland works the other way round. We put a biodegradable cleaning solution on at low pressure, give it time to kill the mould and loosen the dirt, then rinse it off gently. The solution does the work, not the force of the water.

That's why it lasts longer than a blast. The growth is actually killed, so it takes much more time to come back. It's also why it's safe on paint, plaster, Linea, cedar and the rest of the surfaces that don't like being hit hard.

A house wash done this way covers the walls, eaves, window and door frames, and the outside of the gutters. Plants get rinsed before and after. You don't need to be home, as long as we can get around every side and the windows are shut.

When a water blaster is the right tool

We're not against the machine. We use one, on the surfaces that can take it. Older concrete driveways, paths, some retaining walls and patios often need more pressure to lift oil and ground-in dirt. That's a pressure wash or a water blasting job, and we'll say so when we quote.

Newer concrete, painted surfaces, timber decks and anything with a coating should be treated more carefully. If you're unsure, ask. It's a short conversation and it saves a lot of damage.

Weatherboards, plaster and the rest

Soft washing isn't only for villas. Plaster and texture-coated houses, brick, and modern board cladding all take the same approach: low pressure, the right solution, and a proper rinse. The mix and the dwell time change with the surface, but the idea doesn't.

If the house is going to be painted, this is also the way to prep it. A blaster can leave the surface uneven and the timber wet. A soft wash leaves you with a clean wall that can dry properly before the painter starts.

A note on hire machines and DIY

We get why people try it themselves. A hired blaster looks straightforward, and the first pass on a dirty wall can look like it's working. The damage often shows later: lifted paint along the edges of the boards, water inside the joinery, or a garden that's had a strong mix run through it.

If you do want to tidy a small area yourself, stay off the high-pressure lance and be careful with anything you put on the wall. For a whole house, especially two storeys or anything with tired paint, it's safer to have it done properly.

Around Auckland

We soft wash homes across the city, from the old villas in the inner suburbs to newer places further out. The method is the same. The section and the cladding change the time it takes.

For the wider list, see our Auckland cleaning services page. If you want the house done as a standard job, that's a house wash.

Call or text 027 303 8398 for a price. Quotes are free. Tell us what the house is clad in, and a photo of the worst wall helps.

Quick questions

Can you water blast a weatherboard house if you're careful?

We wouldn't. Even at a lower setting, a blaster can lift tired paint, etch soft timber and force water up behind the boards and into the window seals. A soft wash does the same clean without that risk.

Is a soft wash strong enough if the house is really dirty?

Yes. The cleaning solution does the hard work, not the pressure. On a house that hasn't been washed in years the job takes longer, but the method stays the same.

Get a free quote

Tell us what needs a clean and where. We'll come back to you with a price.

Call nowFree quote